| Subject | Text |
| 25" Console TV Need To Release Vacuum Safely | Is there a way to stabalize the vacuum in a CRT tube without causing it to implode, I dont want to j |
| Found this in my 55EX Service Notes | DEAD SET - (-24) VOLT SUPPLY IS DOWN TO (-13) AND SOME OF THE OTHER SUPPLIES WERE ALSO LOW CHECK/RES |
|
|
| Re: 25" Console TV Need To Release Vacuum Safely | [quote:9a7acdf5ff="AshTray900"]Is there a way to stabalize the vacuum in a CRT tube without causing |
| 447s | How to get in the service/factory mode??
first switch off the monitor with power switch.
1)PushV |
| ok i've found where the spring goes, but now i need to find out how to release the cd 'clamp' at the |
| Sadly, no. The fault was an open circuit resistor in the preamp stage, probably from overdriving it. |
| The HT (high-tension) transformer is the transformer usually referred to as the flyback transformer |
| Check out which chipset is used on the motherboard, and then look at the chipset manufacturer's appl |
| please, problem changing a flyback of LG CB561B! | Hi, the big problem is that I live in Brazil and people doesn't make commitments!:
My technician ha |
| dual cd player | thanks for the reply i have checked the loader and when the cd loader didnt come out i tapped the to |
| Re: Remove Picture Tube | [quote:f01c9ab208="newbee"]What is the best/safest way to remove a picture tube from a TV?[/quote:f0 |
| Usually, a solar panel works with maximum efficiency when loaded down to about half the open circuit |
| Veiwsonic 3250 power supply troubles | I have a power supply for one of these flat panels and it had 5 bad electrolytics which I replaced o |
| ip 1000 | :lol:
1. disconnect the power cord
2. press hold power buttom and connect the power cord
3. re |
| Samsung le-m87 firmware issues | I need firmware for a Samsung le-m87 LCD, Samsung will not release this to me but if there any serv |
| APC RT 5000 UPS Info | A few years ago I contacted APC and inquired about purchasing schematics and a service manual for a |
| i have quite alot of repair notes from memory on this model but i will not be able to see them until |
|
|
| Inverters delivering sine wave are fairly cheap today, so i don't think it is a very economic DIY pr |
| CANON i-series waste ink tank error RESET | Start with the printer OFF
>
> 1. Hold down RESUME and then hold down POWER
> 2. release |
| Honeywell HF810 Mega Turbo Floor Fan Disassembly | This fan stopped working suddenly one day. I spent $50 on this fan and I'd really like to keep it. |
| never had a buffer board fail on that model, have changed 32 of the pdps used in that series of plas |
| A light bulb has very low resistance when it is cold, and will draw a huge startup current (up to te |
| 50MP1 Flashing LED | deejayess:-
1) Power off the unit (using power switch on underside of product)
2) Press & ho |
| Ok First, thumbs up to your determination in getting to the switch :)
Yes the switch in questi |
| I need advice on pocket pc's...palm.... | Hi!,
Im new to this forum, this is my first post actually, I am in need of a pocket pc/palm, I |
| I would not recommend using transformers at all in a power factor meter, in order to avoid problems |
| remote control URC24 | Hello,
These universal remote works fine on most devices !
First, you have to program the remote |
| In general, majority of remotes(including Sony) are snapped together & not meant to be taken ap |
| Re: Remove Cover | [quote:4ad1016cea="starchaser09"]Hi all,
My question to anyone is how to remove the cover to get |
| New version 3.0 beta of PinoutMaster available for download | New version 3.0 beta of PinoutMaster available for download ( thanks to Profegramma Software)
Feat |